Quantcast
Channel: Automotive Repair Manual Download and Reviews » Search Results » 2007 avalanche fuse box list
Viewing all articles
Browse latest Browse all 12

2007 Honda Odyssey Fog Lights Installation – Page 1

$
0
0

2007 Honda Odyssey Fog Lights Installation Procedures

fog lights1. Be sure you have the anti-theft code for the radio, then write down the radio station presets.
2. Disconnect the negative cable from the battery.
3. Remove the radiator cowl (ten clips).
4. Take away the front bumper. On either side, pull the interior fender back, and remove the 2 self-tapping screws. Take away the eight clips. Remove the 2 bolts, and take away the front bumper. Place the front bumper on a blanket.
Remove the Front Bumper
5. To guard the bumper, apply masking tape to the front aspect of the bumper around the appropriate and left fog mild opening.
6. On the inside of the bumper, align the template with the left fog lights mounting position. Utilizing a pushpin, mark the bumper at every of the six areas on the template. Ignore the pre-scribed line.
7. Using a felt-tip pen, mark the bumper in the space shown.
8. Flip the template over, and mark the opposite facet of the bumper the identical way.
9. While wearing eye protection, drill one 7 mm hole and 4 10 mm holes on the marked locations. Start with a 3 mm drill bit, and end with a 7 mm or a 10 mm drill bit.
10. On the outside of the entrance bumper, use a hacksaw blade to cut the bumper on the fog light opening alongside the three sides.
11. On the inside of the front bumper, minimize out the fog light opening from the entrance bumper using a hacksaw blade. Take away any burrs, and take away the masking tape.
Installing the Fog Lights
12. Install the left bracket to the front bumper utilizing three self-tapping screws.
13. Insert the fog lights by the opening in the entrance bumper and into the bracket.
14. Install the fog lights to the bracket utilizing one 5 x sixteen mm washer bolt.
15. Repeat steps 9 by 14 to cut the bumper, and set up the fitting fog lights.
Routing the Fog Lights Harness
16. Open the hood. Take away the FI-ECU cowl (two clips).
17. Remove the two beneath-hood fuse/relay box bolts, and slide the fuse/relay field to the side.
18. Remove the underneath-hood fuse/relay field cover (4 retaining tabs).
19. Take away the under-hood fuse/relay field decrease cowl from the beneath-hood fuse/relay box (six retaining tabs).


Viewing all articles
Browse latest Browse all 12

Trending Articles